Where to Place a WiFi Extender
Place a WiFi extender about halfway between your router and the area with weak WiFi, in a spot where it still gets a clear signal from the router. That middle spot lets the extender pick up the router signal and pass it on to the weak area. Putting it too far away, inside the weak area itself, leaves it with little signal to pass on.
Find the weak spot first
Walk through your home with a phone or laptop and note where video calls freeze, pages load slowly or the WiFi drops. Write down each room with weak WiFi and what you do there, such as work calls or streaming. That list shows which area the extender has to reach and where the signal from the router starts to fall away.
Place it halfway to the weak area
Choose a power outlet about halfway between the router and the weak area, on the same floor if you can. The extender has to hear the router clearly to repeat the signal, so a spot in the middle works better than a spot at the far end. If the weak area is upstairs, try a spot near the stairs or on the landing between floors.
Keep it out in the open
Put the extender on a shelf or table, out in the open and clear of the floor, rather than behind furniture or inside a cabinet. A raised spot with clear space around it helps the signal spread into the room. Leave the vents clear and keep the extender away from a heater, a radiator or a damp spot.
Keep it clear of thick obstacles
Thick walls, floors, metal cabinets, mirrors and large appliances can weaken a WiFi signal, so avoid placing the extender directly behind them. A spot with a clear line toward the router and toward the weak area gives a better result than a spot tucked behind a fridge or a metal shelf. Move it to the other side of the wall if the signal stays weak.
Check the spot and move it if needed
After you plug in the extender and set it up, go to the weak area and try the things that failed there before, such as a video call or a stream. If the connection still drops, move the extender one outlet closer to the router and try again. Move it in small steps until the weak area works and the extender still holds a link to the router.
What you need

TP-Link Deco X55 AX3000
A Wi-Fi 6 AX3000 mesh system in a 3-pack with 3 Gigabit ports per unit and support for Ethernet backhaul.
View on Amazon
Amazon eero 6 mesh
A Wi-Fi 6 mesh router with coverage up to 1,500 sq. ft. and support for internet plans up to 900 Mbps.
View on Amazon
TP-Link AX1800 WiFi 6 Router
A Wi-Fi 6 AX1800 dual-band router with Gigabit ports, Easy Mesh and 4 high-gain antennas.
View on Amazon
NETGEAR Nighthawk
A Wi-Fi 6 AX1800 dual-band router with 4 Gigabit ports, coverage up to 1,500 sq. ft. and support for 20 devices.
View on AmazonThese come from our ranked list Best Wi-Fi Router, which compares them spec by spec.
FAQ
Can I place a WiFi extender in a dead zone?
No. An extender in a dead zone picks up only a weak router signal to repeat, so the weak area stays weak. Place it where the router signal is still clear, about halfway between the router and the dead zone.
Should a WiFi extender sit on the floor?
No, a raised spot works better. Put it on a shelf or table, out in the open, so the signal is not blocked by furniture or the floor itself. Keep it clear of thick walls and metal objects.
Do I need more than one WiFi extender?
It depends on the size of your home and how many weak areas you have. One extender placed halfway to a single weak area often covers it. A mesh system can suit a home with weak WiFi in several rooms, since its units work together.




