How to Use a Router as a Wi-Fi Extender
Yes, a spare router can work as a Wi-Fi extender when it has an access point, repeater or bridge mode. The simplest setup is a cable from the main router to the spare router, with the spare router set to access point mode. A wireless repeater setup works without a cable, but it shares the same wireless link for both directions.
Check what modes your spare router has
Open the spare router's settings page and look for access point, repeater, bridge or WDS mode. The mode names differ by maker, so check the router's manual or support page when the setting is not clear. A router with one of these modes can act as an extender. A mesh router or a router with Easy Mesh can join a mesh network instead, so check for that option too.
Connect the spare router with a cable
For the most reliable setup, run an Ethernet cable from a LAN port on the main router to a LAN port on the spare router, then set the spare router to access point mode. Give the spare router the same network name and password as the main router so your devices move between the two without a new connection. Place the spare router where the main signal is weak, near a power outlet and within reach of the cable.
Set up a wireless repeater instead
When no cable can reach the spot, use repeater mode on the spare router. In the router settings, pick the main network, enter its password, and let the spare router repeat that signal. Put the spare router halfway between the main router and the weak spot, where it still gets a strong signal from the main router. A repeater shares one wireless link, so expect lower speeds than a wired access point setup.
Place the router and check the result
Put the spare router in the open, away from thick walls, large metal objects and other electronics that weaken the signal. After setup, walk to the weak spot with your phone or laptop and check that it connects and loads pages. If the signal is still weak, move the spare router closer to the main router and check again. If it drops often, switch the spare router to a wired access point setup when a cable is possible.
What you need

TP-Link Deco X55 AX3000
A Wi-Fi 6 AX3000 mesh system in a 3-pack that covers up to 6500 sq ft, with 3 Gigabit ports per unit and support for Ethernet backhaul.
View on Amazon
Amazon eero 6 mesh
A Wi-Fi 6 mesh router that covers up to 1,500 sq ft, supports plans up to 900 Mbps and connects 75+ devices.
View on Amazon
TP-Link AX1800 WiFi 6 Router
A Wi-Fi 6 AX1800 dual-band router with Easy Mesh, 4 high-gain antennas and 1.8 Gbps total bandwidth.
View on Amazon
NETGEAR Nighthawk
A Wi-Fi 6 AX1800 dual-band router that covers up to 1,500 sq ft, with 4 Gigabit ports and support for up to 20 devices.
View on AmazonThese come from our ranked list Best Wi-Fi Router, which compares them spec by spec.
FAQ
Can any router work as a Wi-Fi extender?
No. The spare router needs an access point, repeater or bridge mode in its settings. Check the router's manual or support page for those modes before you start.
Should the extender use the same network name?
Yes, use the same network name and password when the spare router runs as an access point, so your devices move between the two routers without a new connection. A repeater setup repeats the same network too.
Is a wired or wireless extender setup better?
A wired access point setup is better when a cable can reach the spot, since it gives the spare router its own link to the main router. A wireless repeater works without a cable but shares one wireless link.




