How to Set Up Two Routers on One Network
Set up two routers on one network by making the first router the main router and the second router an access point or mesh node, with the same network name and password on both. Connect the second router to the first with an Ethernet cable, turn off its routing, and place it where Wi-Fi is weak.
Connect the main router first
Connect the modem to the main router with an Ethernet cable, then set the network name and password in the router app. Check that a phone or laptop connects and loads a page before you add the second router. A working main router gives you a known good starting point, so a problem with the second router is easier to find. Keep the network name and password written down for the next step.
Add the second router as an access point
Connect an Ethernet cable from a LAN port on the main router to the second router. Open the second router settings and switch it to access point mode, which turns off its routing and lets the main router hand out addresses. Give the second router the same network name and password as the main router. Save the settings and restart the second router if its app asks for a restart.
Place the second router for coverage
Put the second router where Wi-Fi is weak, close to an Ethernet port if you use a wired link. Keep it out in the open, away from thick walls, metal shelves and large appliances that weaken the signal. A spot halfway between the main router and the weak area works well, since the second router still needs a clear link back to the main router. Check the signal in that room after you move it.
Check devices move between routers
Walk from the main router toward the second router with a phone and watch which router it uses. A device may hold on to the first router until its signal fades, so turn Wi-Fi off and back on to make it join the nearer router. Open the router app and check that the device shows on the second router. If a device stays on the wrong router, restart that device and check the network name again.
What you need

TP-Link Deco X55 AX3000
A Wi-Fi 6 mesh system with AX3000 speed, 3 Gigabit ports per unit and Ethernet Backhaul, covering up to 6500 square feet with 3 units.
View on Amazon
Amazon eero 6 mesh
A Wi-Fi 6 mesh router covering up to 1,500 square feet, with speeds up to 900 Mbps and support for 75+ devices.
View on Amazon
TP-Link AX1800 WiFi 6 Router
A Wi-Fi 6 router with AX1800 speed, 1.8 Gbps total bandwidth, Easy Mesh and 4 high-gain antennas.
View on Amazon
NETGEAR Nighthawk
A Wi-Fi 6 router with AX1800 speed, 1.8 Gbps total bandwidth, 4 Gigabit LAN ports and coverage up to 1,500 square feet.
View on AmazonThese come from our ranked list Best Wi-Fi Router, which compares them spec by spec.
FAQ
Can two routers share one network name?
Yes. Set the same network name and password on both routers, with the second router in access point mode or as a mesh node. Devices then see one network and join the nearer router.
Do I need a cable between the two routers?
An Ethernet cable gives the steadiest link between the routers. Some mesh systems can link over Wi-Fi instead, but a cable avoids the signal loss of a wireless link between the routers.
Why do devices stay on the wrong router?
A device holds its connection until the signal fades, even when a nearer router is available. Move closer to the second router, turn Wi-Fi off and back on, and check that both routers use the same network name.



