How to Install a Heatsink on an SSD
To install a heatsink on an SSD, shut the computer down and unplug it, then fit the heatsink over a bare drive in its motherboard slot and fasten it as the heatsink manual says. Peel the film off the thermal pad first so the pad touches the drive, and check that the drive still shows up after you power on. Follow the maker's manual for opening the case.
Shut down and unplug first
Shut the computer down fully and unplug it from the wall before you open anything. The maker's manual shows how to open the case and where the SSD slot sits, so follow those steps rather than guessing. Touch a bare metal part of the case to discharge static before you handle the drive, and keep screws and the side panel aside while you work.
Check the heatsink fit first
Check that the heatsink matches the drive and the slot before you fit anything. A heatsink made for a bare drive in a motherboard slot will not fit a drive in a caddy or a bay, so compare the heatsink with the drive in your hand. Read the heatsink manual for the parts in the box, and lay them out in order before you start.
Fit the thermal pad and heatsink
Peel the film off the thermal pad on the heatsink, then set the heatsink over the drive so the pad sits flat on the drive's top. Line up the screw holes or the clip with the slot, and fasten the heatsink as the heatsink manual says. Do not force a screw that will not turn, and do not leave the film on the pad, since the pad must touch the drive to work.
Power on and check the drive
Put the side panel back on and fasten it, then plug the computer back in and power it on. Open the BIOS or the operating system's disk tool and check that the drive shows up. If the drive does not show up, shut the computer down, unplug it and check that the drive and the heatsink sit flat in the slot. A drive that shows up is ready to be set up as storage.
What you need

PNY CS900 500GB 2.5" SATA III Internal
A 500 GB 2.5-inch SATA III SSD with read speeds of up to 550 MB/s and a 3-year warranty.
View on Amazon
SanDisk SSD Plus
A 500 GB 2.5-inch 7mm SATA III SSD with read speeds of up to 545 MB/s and a 3-year limited warranty.
View on Amazon
PNY CS900 250GB 2.5" SATA III Internal
A 250 GB 2.5-inch SATA III SSD with read speeds of up to 535 MB/s and a 3-year warranty.
View on Amazon
Kingston 960GB A400 SATA3 2.5" Internal SSD
A 960 GB 2.5-inch SATA3 SSD with a limited 3-year warranty, made as a hard drive replacement.
View on AmazonThese come from our ranked list Best Internal SATA SSD, which compares them spec by spec.
FAQ
Do 2.5-inch SATA SSDs need a heatsink?
No. The drives shown here are 2.5-inch SATA drives that mount in a drive bay, and a heatsink fits a bare drive in a motherboard slot instead. Check your computer manual for where your drive goes before you buy a heatsink.
Should I remove the film from the thermal pad?
Yes. Peel the film off before you fit the heatsink, so the pad sits flat on the drive. A pad with the film still on it cannot touch the drive, and the heatsink will not work as the manual describes.
What do I check after fitting the heatsink?
Power on and check that the drive shows up in the BIOS or the operating system's disk tool. If it does not show up, shut the computer down, unplug it and check that the drive and heatsink sit flat in the slot.




