How to Connect an SSD to a Motherboard
Connect a 2.5-inch SATA SSD to a motherboard with two cables: a SATA data cable from the drive to a SATA port on the motherboard, and a SATA power cable from the power supply to the drive. Shut the computer down and unplug it before you open the case, and mount the drive in a 2.5-inch bay first.
Shut down and unplug the computer
Shut the computer down, unplug the power cable, and follow the manual for your case and motherboard. Opening a computer while it has power can damage parts, so work with the power off and the cable out. Keep the screws you remove in one place so you can put the side panel back on.
Mount the SSD in a 2.5-inch bay
Find a 2.5-inch drive bay in the case and slide the SSD into it, or fasten it to the case's mounting bracket. Use the screws the case provides, or the tool-free mount if your case has one. The drive's SATA connectors face outward so the cables can reach them, and the drive sits flat in the bay.
Connect the SATA data cable
Plug one end of a SATA data cable into the small connector on the SSD and the other end into a SATA port on the motherboard. The connector fits one way, so line up the L-shaped key before you push it in. Use any free SATA port on the board and note which one you used.
Connect the SATA power cable
Take a SATA power cable from the power supply and plug it into the wider connector on the SSD. It also fits one way, so line up the key before you push it in. If no free power cable reaches the drive, check the cables that came with the power supply for a spare SATA connector.
Check that the drive shows up
Close the case, plug the power cable back in, and switch the computer on. Open the system setup or the operating system's disk settings to confirm the drive appears. A new drive still needs to be initialized and formatted before it shows up with a drive letter, so finish that step in the operating system.
What you need

Lexar 512GB NS100 Internal SSD 2.5" SATA
A 512GB 2.5-inch SATA III drive with a rated read speed of up to 550 MB/s and a three-year limited warranty.
View on Amazon
PNY CS900 500GB 2.5" SATA III Internal
A 500GB 2.5-inch SATA III drive with read speeds of up to 550 MB/s and write speeds of up to 500 MB/s.
View on Amazon
PNY CS900 250GB 2.5" SATA III Internal
A 250GB 2.5-inch SATA III drive with read speeds of up to 535 MB/s and write speeds of up to 500 MB/s.
View on Amazon
Crucial BX500 240GB 3D NAND SATA 2.5-Inch
A 240GB 2.5-inch SATA drive with a rated read speed of up to 540 MB/s and a 3-year limited warranty.
View on AmazonThese come from our ranked list Best SSD Internal Hard Drive, which compares them spec by spec.
FAQ
Do I need a SATA cable for a 2.5-inch SSD?
Yes. A 2.5-inch SATA SSD connects with a SATA data cable to the motherboard and a SATA power cable from the power supply. Some cases and motherboards include a data cable in the box, so check what came with yours.
Where does the SSD go in the case?
A 2.5-inch SSD mounts in a 2.5-inch drive bay or on a mounting bracket in the case. Secure it with the screws or tool-free mount the case provides, then connect the cables before you close the case.
Why does my new SSD not show up after I install it?
A new drive often needs to be initialized and formatted in the operating system before it appears with a drive letter. Open your operating system's disk settings, find the new drive, initialize it, and create a volume on it.



