How to Install a GPU Vertically
To install a GPU vertically, shut the PC down, unplug it, and fit a vertical mount bracket with a riser cable inside the case. Connect the riser cable to the motherboard PCIe slot, seat the card in the riser, and secure it with the bracket screws. Connect the power cables, close the case, and boot to check the display.
Shut the PC down and unplug it
Shut the PC down through the operating system and unplug the power cable from the wall before you open the case. Follow the case manual to remove the side panel, and follow the motherboard manual for the slot layout. Check the case manual for vertical mount slots and for the card length and thickness the mount accepts, so the card fits before you start.
Fit the vertical mount and riser cable
Fit the vertical mount bracket into the case slots the manual shows, and fasten it with the screws that come with the mount. Connect the riser cable to the motherboard PCIe slot and route it to the bracket without sharp bends. Check that the riser cable matches the PCIe generation your motherboard lists, and that the connector sits fully in the slot.
Seat the card and connect power
Slide the graphics card into the riser connector until it sits fully in place, then fasten the card bracket to the mount with the screws. Connect the power cables from the power supply to the card, and check that each plug is fully seated. Check that the card sits level, clears the side panel, and leaves room for air to move around it.
Close up, boot, and check the display
Replace the side panel and plug the power cable back in. Connect the monitor to the HDMI or DisplayPort output on the card, then boot the PC and check that a picture appears. If the screen stays blank, shut the PC down, unplug it, and reseat the card, the riser cable, and the power cables. If the problem stays, contact the card maker.
What you need

ASUS PRIME GeForce RTX 5060 Ti 16GB
A 16GB GDDR7 card with a 2.5-slot design and SFF-ready build, with PCIe 5.0 and an HDMI output.
View on Amazon
ASUS Prime GeForce RTX 5060 Ti 8GB
An 8GB GDDR7 card weighing 2.65 lb, with a 2.5-slot design, PCIe 5.0 and an HDMI output.
View on Amazon
MSI Gaming RTX 3050 LP 6G OC Graphics Card
A low-profile 6GB GDDR6 card with HDMI 2.1a and DisplayPort outputs and a 1492 MHz boost clock.
View on Amazon
NVIDIA RTX 4000 SFF Ada Generation Workstation Ada Lovelace Architecture Dual Slot Low Profile Professional Graphics Board 900-5G192-2571-000 VD8465
A dual-slot low-profile workstation card with Ada Lovelace architecture for small-form-factor builds.
View on AmazonThese come from our ranked list Best Sff GPU, which compares them spec by spec.
FAQ
Does a vertical GPU need a riser cable?
Yes. A vertical mount holds the card away from the motherboard slot, so a riser cable links the card to the slot. Check that the riser matches the PCIe generation your motherboard lists.
Will my case fit a vertical GPU?
Check the case manual for vertical mount slots and the clearance it lists for card length and thickness. A card that is too long or too thick for the mount will not fit, so check before you buy the mount.
Can any graphics card mount vertically?
Any card that fits the mount and the riser can mount vertically. Check the card length, thickness, and power connectors against the mount and the case manual first.




