How to Connect Power Cables to a Motherboard
To connect power cables to a motherboard, plug the power supply's main connector into the wide socket on the board, then connect the CPU power cable near the top of the board and the graphics card cable if your card has one. Each connector is keyed so it only fits one way. Shut the PC down and unplug it before you touch any cable inside the case.
Shut down and open the case
Shut the PC down from the shutdown menu, then unplug the power cord from the wall and from the power supply. Press the case power button once with the cord out to drain any charge left in the system. Open the side panel by following the steps in your case manual.
Find the main power socket
The main power socket is the wide connector on the motherboard, along the edge nearest the front of the case. Take the matching wide connector from the power supply and line up its clip with the tab on the socket. Push it straight in until the clip snaps over the tab and the connector sits flat, with no gap at either end. A loose main connector is a common cause of a PC that will not start.
Connect the CPU power cable
The CPU power socket sits near the top of the motherboard, close to the processor. Route the CPU power cable from the power supply to that socket, keeping it clear of fans so it cannot catch in a blade. Line up the clip with the tab and press the connector in until it sits flat. If the socket on your board takes a wider connector than the cable you hold, check your power supply manual for a second CPU cable.
Connect graphics card and drives
If your graphics card has a power socket, connect the matching cable from the power supply to it and press it in until the clip holds. Connect a power cable to each drive in the same way, using the flat connector that fits the drive socket. Check every connector once more, then close the side panel, plug the power cord back in and press the power button. If the fans spin and the screen shows a picture, the cables are connected.
What you need

CORSAIR RM1000e ATX 3.1 PCIe 5.1 Ready 1000W Power Supply
A 1000 W fully modular power supply with a native 12V-2x6 cable, ATX 3.1 and PCIe 5.1 support, a 120mm fan and a 7 year manufacturer warranty.
View on Amazon
CORSAIR RM1000x ATX 3.1 PCIe 5.1 1000W Power Supply
A 1000 W fully modular power supply with a native 12V-2x6 connector, ATX 3.1 and PCIe 5.1 support and a 10 year manufacturer warranty.
View on Amazon
MSI MAG A850GL PCIE5
An 850 W fully modular power supply with 80 PLUS Gold certification, ATX 3.1 and PCIe 5.1 support and a 10 year limited manufacturer warranty.
View on Amazon
Thermaltake Toughpower GT 850W ATX 3.1 Standard Power Supply
An 850 W fully modular power supply with 80 Plus Gold efficiency, ATX 3.1 and PCIe 5.1 support and a 5 year manufacturer warranty.
View on AmazonThese come from our ranked list Best Power Supply, which compares them spec by spec.
FAQ
Can I plug a power cable in the wrong way?
No. Each motherboard power connector is keyed with a clip and a tab, so it only fits its own socket in one direction. If a connector will not slide in, turn it around and line up the clip instead of forcing it.
What if my PC will not start after connecting the cables?
Check that the main power connector and the CPU power cable sit flat with their clips over the tabs. Make sure the power cord is plugged in at the wall and the switch on the power supply is on, then press the power button again.
Do I need to connect every cable from the power supply?
No. With a fully modular power supply you only connect the cables your build uses, such as the main, CPU and graphics card cables. Leave the spare cables out of the case so air can move freely.




