How to Connect a Power Supply
To connect a power supply, shut the PC down and unplug it, mount the power supply in the case, and plug its cables into the motherboard, processor, graphics card and drives. Use only the cables that came with the power supply, and follow the manuals for the power supply and the motherboard. Check each plug seats fully before you switch the PC on.
Shut the PC down and unplug it
Shut the PC down through the operating system, then switch the power supply off and pull the power cord from the wall. Press the power button once more to drain any charge left in the system. Follow the manual for your case and power supply before you open the case, and keep the power cord out until every cable is connected.
Mount the power supply in the case
Set the power supply into its bay in the case and line up the screw holes with the case, then fasten it with the screws from the case or the power supply box. Point the fan toward the vent or opening in the case that the manual shows, so air can move through it. Keep the cables clear of the fan so air can move freely when the PC runs.
Connect the motherboard and processor cables
Find the wide cable from the power supply that fits the motherboard socket and push it in until the clip catches. Find the smaller processor cable and push it into the socket near the processor until it clicks. Use only the cables that came with your power supply, since cables from another power supply can have different wiring. Check each plug by its shape and the socket shown in the motherboard manual.
Connect the graphics card and drives
Plug the 12V-2x6 cable into the graphics card until it seats fully, and push it in straight so the plug sits flush with the socket. Connect the power cables to each drive and to any other part that takes power from the supply, following the manuals for those parts. Tie the loose cables out of the way of fans and air flow, then plug the power cord back in and switch the PC on.
What you need

CORSAIR RM1000e ATX 3.1 PCIe 5.1 Ready 1000W Power Supply
A 1000W fully modular power supply with a native 12V-2x6 cable, ATX 3.1 and PCIe 5.1 support, and a 120mm rifle bearing fan.
View on Amazon
CORSAIR RM1000x ATX 3.1 PCIe 5.1 1000W Power Supply
A 1000W fully modular power supply with a native 12V-2x6 connector for graphics cards, ATX 3.1 and PCIe 5.1 support, and a 10-year warranty.
View on Amazon
MSI MAG A850GL PCIE5
An 850W fully modular power supply with 80 PLUS Gold certification, a native dual-color 12V-2x6 cable, and a 10-year warranty.
View on Amazon
Thermaltake Toughpower GT 850W ATX 3.1 Standard Power Supply
An 850W fully modular power supply with 80 PLUS Gold efficiency, a native 12V-2x6 connector, Smart Zero Fan, and low-profile flat black cables.
View on AmazonThese come from our ranked list Best Power Supply, which compares them spec by spec.
FAQ
Can I use cables from another power supply?
No. Cables from another power supply can have different wiring, even when the plugs look the same. Use only the cables that came with your power supply, and contact the maker if you need another cable.
How do I know the cables are plugged in fully?
Each plug should sit flush with its socket and the clip should catch. Pull each cable gently to check it stays in place, and look at the plug from the side to see that no pins show. If a plug feels loose, push it in again until it clicks.
What should I do if the PC does not switch on?
Check that the power cord is pushed in at both ends and the switch on the power supply is on. Check each cable in the case, then follow the steps in the power supply manual. If the PC still does not switch on, contact the maker.




