How to Calibrate a Touch Screen Monitor
To calibrate a touch screen monitor, open your system's touch calibration tool, tap each target as it appears, and save the result. On Windows, search for 'Calibrate the screen for pen or touch input' and follow the on-screen crosses. If the taps land in the wrong place, run the tool again on the right display and check that both the video and USB cables are connected.
Connect video and USB first
A touch screen needs a video cable for the picture and a USB cable for the touch signal. Connect the monitor with its video cable, then connect the USB cable that carries touch. The Dell monitors here connect over HDMI, and the Samsung uses HDMI and D-sub ports. If touch does not respond at all, check the USB cable first before you change any setting.
Open the calibration tool
On Windows, search for Calibrate the screen for pen or touch input and open Tablet PC Settings. If you have more than one display, use the Setup button to pick the touch screen before you start. Tap each cross as it appears, using a finger or a stylus, and hold still until the next target shows. Save the calibration when the tool finishes, and tap the screen to check that the pointer follows your finger.
Check the edges and corners
After calibration, tap the corners and edges of the screen and watch where the pointer lands. If taps near an edge land wide of your finger, run the calibration again and tap each target in the center. Check that the display runs at its native resolution, such as 1920x1080 on the Dell monitors here, since a scaled display can shift touch points. If the error stays in one corner, check the screen for dirt or a screen protector lifting at the edge.
When calibration does not fix it
If taps still land in the wrong place after a fresh calibration, check the maker's driver or utility for the touch screen and install the version it lists for your model. Try another USB port and another cable, since a loose connection can drop touch input. If the screen still misses taps in the same spot, contact the maker instead of opening the monitor.
What you need

Dell 24 Plus Monitor S2425HSM
A 23.8-inch FHD monitor with a 144Hz refresh rate, HDMI and height, tilt, pivot and swivel adjustment for a desk setup.
View on Amazon
Dell 27 Plus Monitor S2725HSM
A 27-inch FHD monitor with a 144Hz refresh rate, HDMI and the same height, tilt, pivot and swivel adjustment in a larger size.
View on Amazon
Sceptre 27-inch Gaming Monitor 1ms E275W-FW100T
A 27-inch monitor with a 100Hz refresh rate, two HDMI ports, a DisplayPort port and built-in speakers.
View on Amazon
Samsung 24-inch Essential S3 (S36GD) 1800R Curved Computer Monitor
A 24-inch curved FHD monitor with a 100Hz refresh rate, HDMI and D-sub ports and a Game Mode.
View on AmazonThese come from our ranked list Best Computer Monitor Screen, which compares them spec by spec.
FAQ
Do I need a USB cable to calibrate a touch screen?
Yes, touch data travels over USB as well as the video cable, so connect both before you calibrate. If touch does not respond at all, check the USB cable and port first.
Why do my taps land in the wrong place?
The calibration may be old, or the tool may have been run on the wrong display. Run the calibration again on the touch screen, tap each target in the center, and check that the display runs at its native resolution.
Can I calibrate a touch screen without a stylus?
Yes, tap each target with your finger and hold still until the next one shows. A stylus works too, but your finger is the input you will use most, so calibrate with it.




