Monitor Mount Screw Sizes Explained
There is no single screw size for monitor mounts. The size depends on the mounting pattern on the back of your monitor and the mount you use, so check the monitor manual and the mount manual for the thread size and length you need. Use the screws that come with the mount, and do not force a screw that does not turn freely.
Find the mounting pattern on your monitor
Look at the back of the monitor for threaded holes arranged in a square or rectangle. The manual for the monitor gives the pattern and the screw thread that fits it. That pattern tells the mount maker which plate and screws to supply, so keep it with you when you shop for a mount. If the manual is not at hand, the support page for your model gives the same mounting details.
Use the screws that come with the mount
Mount makers supply screws to match the plate and the thread in the monitor. Start the screws by hand and turn them until they seat, then tighten them. A screw that binds or stops early is the wrong thread or the wrong length, so back it out and check the manual again. Do not use a longer screw in place of the one in the kit, because a screw that goes in too far can reach parts inside the monitor.
Check screw length before you tighten
Screw length matters as much as thread size. A screw that is too short will not hold the plate, and a screw that is too long can press against parts inside the monitor. The mount manual gives the length for the pattern on your monitor, and spacers or washers in the kit change how far a screw reaches. Fit the plate without screws first, check that the holes line up, and confirm the length in the manual before you tighten anything.
Fit the monitor to the mount plate
Set the monitor face down on a soft, flat surface with the stand removed, following the steps in the monitor manual. Line up the plate with the threaded holes and start the screws by hand before you tighten any of them. Tighten them in turn, a little at a time, until the plate sits flat against the back of the monitor. Lift the monitor by the mount or the frame, not by the screen, and check that the plate stays flat and the screws stay seated.
What you need

Dell 24 Monitor SE2426H
A 23.8-inch 1920x1080 IPS monitor with a 144Hz refresh rate, 2x HDMI and tilt, at 7.43 lb.
View on Amazon
Dell 27 Gaming Monitor SE2726HG
A 27-inch 1920x1080 IPS monitor with a 240Hz refresh rate, 2x HDMI and DisplayPort 1.4, at 8.2 lb.
View on Amazon
Acer 23.8-inch Office Monitor KB242Y G0bi
A 23.8-inch 1920x1080 IPS monitor with a 120Hz refresh rate, HDMI and VGA, VESA mountable, at 7.72 lb.
View on Amazon
Sceptre 24-inch Gaming Monitor 1ms E248W-FW100T
A 24-inch 1920x1080 monitor with a 100Hz refresh rate, DisplayPort and 2x HDMI, built-in speakers, VESA wall mountable, at 5.8 lb.
View on AmazonThese come from our ranked list Best PC with Monitor, which compares them spec by spec.
FAQ
What if my mount came with more than one screw size?
Use the size in the monitor manual for your pattern. Keep the other screws aside, and do not mix sizes on the same plate.
Can I use screws from a different mount?
Only if the thread and length match the monitor manual. A screw from another kit can look right and still be the wrong thread, so check the manual before you use it.
Do I need to remove the monitor stand first?
Yes, if the stand covers the mounting holes or stops the plate from sitting flat. Follow the steps in the monitor manual to remove it, and keep the stand and its screws together.



