Amazon Black Friday Week deals

Paid link

PC Components · How-to guide

How to Install Motherboard Standoffs

We earn a commission when you buy through our links, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.
Short answer

Install motherboard standoffs by matching each standoff in the case to a mounting hole on your motherboard. Shut the computer down, unplug it, and follow the case and motherboard manuals first. Place standoffs only where the board has holes, then set the board on them and screw it down.

  1. Shut down and open the case

    Shut the computer down and unplug it before you open the case. Follow the maker's manual for the case and for the motherboard. Lay the case on its side with the motherboard tray facing up. Take out any board that is already fitted, and keep the standoffs and screws that came with the case together.

  2. Match standoffs to the board holes

    Hold the motherboard over the tray without screws and line up the rear ports with the opening at the back of the case. Note where each mounting hole on the board sits over a threaded hole in the tray. Form factor decides the pattern, so an ATX board and a Micro-ATX board do not use the same set of holes. Lift the board out again before you fit any standoff.

  3. Screw in the standoffs

    Screw a standoff into each tray hole you marked, using only the standoffs that came with the case. Start each standoff by hand so the thread goes in straight, then turn it until it sits snug against the tray. Do not force a standoff that will not turn by hand at first. Check the case manual if a standoff does not fit the tray hole.

  4. Set the board and screw it down

    Lower the motherboard onto the standoffs and check that every hole lines up with a standoff below it. Check that each standoff sits under a mounting hole on the board. Fit a screw through each hole into the standoff below and turn it until snug. The board should sit flat and should not bend or rock on the tray.

What you need

ASUS ROG Strix B550-F Gaming

ASUS ROG Strix B550-F Gaming

An ATX motherboard with AM4 socket and B550 chipset, so the case standoffs must match its ATX mounting holes.

View on Amazon
GIGABYTE B850 AORUS Elite WIFI7

GIGABYTE B850 AORUS Elite WIFI7

An ATX motherboard with AM5 socket and B850 chipset, so the case standoffs must match its ATX mounting holes.

View on Amazon
GIGABYTE B550M K

GIGABYTE B550M K

A Micro-ATX motherboard with AM4 socket and B550 chipset, so the case standoffs must match its Micro-ATX mounting holes.

View on Amazon
MSI PRO B760-P

MSI PRO B760-P

An ATX motherboard with LGA 1700 socket and B760 chipset, so the case standoffs must match its ATX mounting holes.

View on Amazon

These come from our ranked list Best Motherboard, which compares them spec by spec.

FAQ

What do motherboard standoffs do?

Standoffs hold the motherboard above the case tray and give the board screws a threaded post to turn into. Each standoff must sit under a mounting hole on the board.

Can I leave an extra standoff in place?

No. Fit standoffs only at the tray holes that line up with the board holes, and remove any extra standoff before you set the board down.

Do ATX and Micro-ATX boards use the same holes?

No. ATX and Micro-ATX are different form factors with different mounting hole patterns. Hold your board over the tray and mark the holes for that board before you fit standoffs.

Ranked motherboards guides