How to Connect Front Panel Connectors
Front panel connectors plug into the front panel header, a small group of pins on the motherboard. Match each small connector from the case, power switch, reset switch, power LED and hard drive LED, to the pins the board manual shows, then plug the front USB and audio cables into their own headers. Shut the PC down and unplug it before you open the case.
Shut down and unplug the PC
Shut the PC down through the operating system, then switch off the power supply and unplug the power cable from the wall. Wait for the fans and lights to stop, then open the case by following the case manual. Keep the PC unplugged while you work inside it, and follow the motherboard manual for every connector you touch.
Find the front panel header
The front panel header is a small group of pins on the motherboard, and the board manual shows its layout with a diagram. Open the manual to the front panel section and keep the diagram where you can see it while you work. The header holds the pins for the power switch, reset switch, power LED and hard drive LED, so matching the diagram to the pins is the whole job.
Match each connector to its pins
The case cables end in small plugs marked PWR_SW, RESET_SW, PWR_LED and HDD_LED. Read the marking on each plug, then push it onto the pins the manual diagram shows for that marking. The power and reset switches work either way round, but the LEDs have a plus and a minus side, so put the marked wire on the plus pin the manual shows.
Connect the front USB and audio cables
The case also has cables for the front USB ports and the front audio jack, and each one plugs into its own header on the board. Find the USB header and the audio header in the board manual, then push each plug onto the header that matches its marking. A plug that does not fit the header is on the wrong header, so check the manual rather than forcing it.
Check the power button and LEDs
Close the case, plug the power cable back in and switch the power supply on. Press the power button and watch for the fans, the power LED and the hard drive LED. If the power button does nothing, shut down, unplug the PC and check that the power switch plug sits on the right pins. If a LED stays dark, shut down, unplug the PC and turn that LED plug around.
What you need

ASUS ROG Strix B550-F Gaming
An ATX board with an AM4 socket, B550 chipset and DDR4 memory, plus Wi-Fi 6E, HDMI 2.1 and a 3-year warranty.
View on Amazon
GIGABYTE B850 AORUS Elite WIFI7
An ATX board with an AM5 socket, B850 chipset and DDR5 memory, plus Wi-Fi 7, PCIe 5.0 and a 5-year manufacturer warranty.
View on Amazon
GIGABYTE B550M K
A Micro-ATX board with an AM4 socket, B550 chipset and DDR4 memory, plus PCIe 4.0 and a 3-year manufacturer warranty.
View on Amazon
MSI PRO B760-P
An ATX board with an LGA 1700 socket, B760 chipset and DDR4 memory, plus Wi-Fi 6E, Bluetooth 5.3 and a 3-year warranty.
View on AmazonThese come from our ranked list Best Motherboard, which compares them spec by spec.
FAQ
What happens if I plug the power LED in backwards?
The LED stays dark because LEDs only light when the plus wire sits on the plus pin. Shut the PC down, unplug it and turn the LED plug around, then power on again.
Do the power and reset switches need the right way round?
No. The power switch and reset switch are simple push buttons, so they work either way round on their pins. Only the LEDs have a plus and a minus side that must match the manual diagram.
Where do I find the front panel pin layout?
In the motherboard manual, in the front panel section. The manual diagram names each pin, and it is the only layout to trust for your board, since layouts differ between boards.



